![]() ![]() Exported the mastered 24-bit 48k Wave files, one-at-a-time to stereo interleaved files for sample rate conversion to 44.1k with Barbabatch 4, rather than use sB's built-in SRC. R used in Pro Tools and other OSX audio apps. 2 names for dual mono files, instead of the more common convention of. Started sB while holding the option key, to disable any plug-ins from loading. much like PMCD's workflow I've grown accustomed to over the past year. Today's work consisted mainly of the Assemble, Edit, & Burn routine. SoundBlade session_ part 2 OK my soundBlade comPadres, see if your workflow is similar to this: Today I continued from yesterday's soundBlade session where I EQ'd twelve 48k Hippie Country Rock songs, thru my analog loop, without a crash, until after the last song was done. which I'm finding to be very elegant & fully featured, which I'm learning at light speed, especially for an old dog. a long time PT user having to learn an entirely diff editing paradigm, sB. If the answer to #1 is no, still using PT loop, then tell me the work flow that is working for you?Īt this point I wouldn't be 100 percent comfortable flying solo with sB, but it's getting very close. Looks good to me Jeff, I bet both the Lynx and Hedd have good word clocks, esp the Hedd. If answer to above is yes just sB, would this path work (seems like it should but before I commit to sB.asking the experts) Out of a panel in sB -> AES Lynx Aurora -> HEDD 192 DA -> Analog Gear -> HEDD 192 AD -> record to new panel in sB ? I can also see the viability of using a two DAW setup, PT as the source, sB as the destination. Or are you still using your PT loop and then just dragging stuff over to sB.ĭepends on the difficulty of the project, I'm still waaay more comfortable in PT, but on unattended sessions I'm using sB as much as possible. In fact if you hold down your option key on start up, sB disables all plug-ins. I EQ'd 12 songs yesterday using sB loop thru my analog path, and it didn't crash until after I'd done the last song : - ) I didn't use any plug-ins, not even an analyzer. ![]() This week I've got two unattended sessions that I'm doing exclusively in soundBlade, except for the 48k to 44.1k SRC, using Barbabatch for that. Hey Jeff, can't give you a straight black or white answer. ![]() Have you replaced your PT loop now with sB exclusively? J.ho wrote on Wed, 21 November 2007 10:27 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |